Today I will introduce some errors in the design of potato dregs dryer. Technical personnel need to design accurately when designing the potato residue dryer, of course, there are certain errors within the specified range.

  The standard deviation range of the base size and installation position of potato dregs dryer equipment is: the elevation error between the plane and the plane should be less than 20 mm, and only negative errors are allowed, positive errors are not allowed; the total length of the slope error is less than 20 mm, negative errors are allowed at the material end and positive errors are not allowed; the error between the non-planes on the upper plane should be less than 5 mm per meter, and the total length should be less than 10 mm per meter. The error between the external dimensions of the equipment parts and the position of the base coordinates on the longitudinal and transverse axes shall be less than 20 mm. These dimensional errors are within the specified range, and within this range of errors are qualified products. Out of this range of errors are defective products, which will affect the later production operation and may not complete the work during assembly. For customers, although it is not necessary to know this size so clearly, they also need to know the approximate error range, so that they can also judge whether a part is not assembled and qualified.

  The above is an introduction to the size error of potato residue dryer, I hope it will be helpful to you.