First, the device according to the dryer needs to be stringent standards on the assembly drawing and foundation construction figure. Its components and its response to wiping , finishing clean and fully equipped.

Second, because the grain dryer is a long body of large equipment, which means and methods should be carried out in this order :

1. Designated root Bottom line: the right to cross the line, elevation lines and standard plate in the middle of laying the foundation board to reach using standard convenience, accurate and not think about the base unit is withheld.

2. The device base and tug : leveled horn orientation, draw the base and the middle line tugboat, in accordance with the drawings needs, identify the base and the tug of device orientation, positive tone flat , first foundation hole grouting, concrete reach a certain intensity, tighten the bolt, after the review of qualified, then the device cylinder.

3. The device cylinder and rolling circle: first rolling ring mounted on the cylinder, when the demand stick concave joints staggered to a positive and negative equipment and adjust the thickness of the horn, the touch ring and the concave roll joints persist corresponding gap, not common, and spot concave joint bolt head and the cylinder body.

4. The device gear: Front view butt plane interface device shall not bump marks, the big gear and the outer cylinder wiping clean the touch, then beware of the two halves of good gear and tighten the connector screws, put the gear mounted on the barrel body. Shift cylinder, check runout and lateral swing gear until calibrated qualified.

5. The device pinion, speed reducer and motor: has assembled a large gear, adjust large pinion meshing parameters and rules needs to reach the equipment, fixed pinion gear position based on electromechanical machines.

6.The device gear cover to marginal gear spacing symmetry.

For more details, welcome to Dingli company know.